Holding small work pieces

Thread Modes

Holding small work pieces

B34VD
Unregistered

03-11-2012, 05:51 PM

I use a 5c collet set up a lot for round parts. I have also machined a small "tit" to a piece and then threaded it. Screwed it in to a larger base material that I could clamp in a mill. Machine what I needed and the removed the threaded piece.

« Next Oldest | Next Newest »

Messages In This Thread

Holding small work pieces - by DaveH - 03-08-2012, 02:38 PM

RE: Holding small work pieces - by EdK - 03-08-2012, 04:48 PM

RE: Holding small work pieces - by B34VD - 03-11-2012, 05:51 PM

RE: Holding small work pieces - by Bogstandard - 03-30-2012, 02:08 AM

RE: Holding small work pieces - by EdK - 03-30-2012, 07:10 AM

RE: Holding small work pieces - by DaveH - 03-30-2012, 08:57 PM

RE: Holding small work pieces - by Highpower - 03-30-2012, 10:11 PM

RE: Holding small work pieces - by EdK - 03-30-2012, 10:14 PM

RE: Holding small work pieces - by Highpower - 03-30-2012, 10:32 PM

RE: Holding small work pieces - by EdK - 03-31-2012, 08:39 AM

RE: Holding small work pieces - by Wongster - 03-30-2012, 11:03 PM

RE: Holding small work pieces - by DaveH - 03-31-2012, 10:17 AM

RE: Holding small work pieces - by Highpower - 04-01-2012, 11:56 AM

RE: Holding small work pieces - by Wongster - 03-31-2012, 10:47 PM

RE: Holding small work pieces - by DaveH - 04-01-2012, 02:45 AM

RE: Holding small work pieces - by ToolCat - 04-01-2012, 09:23 PM

RE: Holding small work pieces - by DaveH - 04-01-2012, 11:24 PM

RE: Holding small work pieces - by krv3000 - 04-02-2012, 02:16 AM

Users browsing this thread: 2 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me