MetalworkingFun Forum › Machining › Projects v
pin vice

Thread Modes
pin vice
Micktoon Offline
Junior
****
Posts: 638
Threads: 43
Joined: Sep 2012
Location: England
#19
09-17-2012, 12:52 PM
Good Job again there Bob WorthyWorthy Good as new, I have a couple of these and will see what the markings are on them, I have never looked close at them before, they might have the other half of the name that is on yours ?.
Cheers Mick.
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
pin vice - by krv3000 - 07-02-2012, 04:50 PM
RE: pin vice - by RobWilson - 07-02-2012, 04:55 PM
RE: pin vice - by doubleboost - 07-02-2012, 04:59 PM
RE: pin vice - by DaveH - 07-02-2012, 05:03 PM
RE: pin vice - by krv3000 - 07-02-2012, 05:39 PM
RE: pin vice - by stevec - 07-02-2012, 05:48 PM
RE: pin vice - by doubleboost - 07-02-2012, 05:55 PM
RE: pin vice - by DaveH - 07-02-2012, 06:01 PM
RE: pin vice - by EdK - 07-02-2012, 06:28 PM
RE: pin vice - by Mayhem - 07-02-2012, 07:33 PM
RE: pin vice - by krv3000 - 07-03-2012, 01:43 AM
RE: pin vice - by krv3000 - 07-04-2012, 06:41 AM
RE: pin vice - by Bill Gruby - 07-04-2012, 07:09 AM
RE: pin vice - by krv3000 - 07-05-2012, 06:22 PM
RE: pin vice - by Highpower - 07-05-2012, 09:36 PM
RE: pin vice - by krv3000 - 07-06-2012, 05:18 PM
RE: pin vice - by Rickabilly - 09-17-2012, 09:24 AM
RE: pin vice - by PixMan - 09-17-2012, 11:29 AM
RE: pin vice - by Rickabilly - 09-17-2012, 01:38 PM
RE: pin vice - by Micktoon - 09-17-2012, 12:52 PM
RE: pin vice - by DaveH - 09-17-2012, 02:41 PM
RE: pin vice - by ETC57 - 09-17-2012, 03:13 PM



Users browsing this thread: 4 Guest(s)