Request for service - lathe related.
#17
Ed
Steve summed it up before I got on line. The oiler puts the oil under the apron and as I see it the wipers hold it in there. The Summit came with rubber wipers, it has an automatic feeder that pumps oil out of the apron. The tailstock only has wipers on the front, when you feel it getting hard to shove a smear of oil on the ways and pull it back onto it and all is good. The summit even has a wiper seal on the tailstock ram, and the cross slide. They must have felt keeping the swarth out was important.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Request for service - lathe related. - by Kaoma - 09-15-2012, 09:49 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 09:27 AM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:20 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:08 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:48 PM
RE: Request for service - lathe related. - by EdK - 09-17-2012, 05:37 AM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 03:49 PM
RE: Request for service - lathe related. - by f350ca - 09-16-2012, 06:44 PM
RE: Request for service - lathe related. - by EdK - 09-22-2012, 08:36 PM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 09:04 AM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 01:00 PM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 05:47 PM
RE: Request for service - lathe related. - by EdK - 09-25-2012, 10:23 AM
RE: Request for service - lathe related. - by EdK - 09-25-2012, 11:22 AM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 08:29 AM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 02:31 PM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 05:31 PM
RE: Request for service - lathe related. - by EdK - 09-27-2012, 05:48 AM



Users browsing this thread: 1 Guest(s)