09-16-2012, 06:10 PM
Rick,
I bought the welder new a couple of years ago and I'm the only one that has used it. I haven't even run a half a spool through yet, (that would be the small spools, not the 8" spools.)
On 1/8" steel, is it better to push or pull the torch or does it even matter? I've only used the pulling method so far.
Ed
I bought the welder new a couple of years ago and I'm the only one that has used it. I haven't even run a half a spool through yet, (that would be the small spools, not the 8" spools.)
On 1/8" steel, is it better to push or pull the torch or does it even matter? I've only used the pulling method so far.
Ed