MetalworkingFun Forum › Machinery › Lathes v
Request for service - lathe related.

Thread Modes
Request for service - lathe related.
krv3000 Offline
Senior
*****
Posts: 1,520
Threads: 157
Joined: Feb 2012
Location: uk
#16
09-16-2012, 04:52 PM
well you cud mack them out of plastic rather than steel on my lath their was no wipers on the crosslide so i drilled and tapt m5 and made me wipers out of felt then made the wiper support out of plastic it works well
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
Request for service - lathe related. - by Kaoma - 09-15-2012, 09:49 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 09:27 AM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:20 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:08 PM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 01:48 PM
RE: Request for service - lathe related. - by EdK - 09-17-2012, 05:37 AM
RE: Request for service - lathe related. - by EdK - 09-16-2012, 03:49 PM
RE: Request for service - lathe related. - by krv3000 - 09-16-2012, 04:52 PM
RE: Request for service - lathe related. - by EdK - 09-22-2012, 08:36 PM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 09:04 AM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 01:00 PM
RE: Request for service - lathe related. - by EdK - 09-23-2012, 05:47 PM
RE: Request for service - lathe related. - by EdK - 09-25-2012, 10:23 AM
RE: Request for service - lathe related. - by EdK - 09-25-2012, 11:22 AM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 08:29 AM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 02:31 PM
RE: Request for service - lathe related. - by EdK - 09-26-2012, 05:31 PM
RE: Request for service - lathe related. - by EdK - 09-27-2012, 05:48 AM



Users browsing this thread: 7 Guest(s)