MetalworkingFun Forum › Machining › General Metalworking Discussion v
Mill, drill, and tap a socket

Thread Modes
Mill, drill, and tap a socket
Wawoodman
Unregistered
 
#7
09-16-2012, 03:04 PM
Thanks, Willie, I'm going to try that.

Meanwhile, when I woke up, it was way too early to go to the hardware store for a ball knob. And then I think, "We have a lathe! We don't need no stinkin' hardware store!" Rotfl

And here it is!


Attached Files Thumbnail(s)
   
Reply
Thanks given by:


Messages In This Thread
Mill, drill, and tap a socket - by Wawoodman - 09-15-2012, 11:30 PM
RE: Mill, drill, and tap a socket - by Highpower - 09-16-2012, 12:25 AM
RE: Mill, drill, and tap a socket - by stevec - 09-16-2012, 07:08 AM
RE: Mill, drill, and tap a socket - by Wawoodman - 09-16-2012, 03:13 PM
RE: Mill, drill, and tap a socket - by PixMan - 09-16-2012, 07:45 AM
RE: Mill, drill, and tap a socket - by Wawoodman - 09-16-2012, 08:05 AM
RE: Mill, drill, and tap a socket - by Highpower - 09-16-2012, 12:21 PM
RE: Mill, drill, and tap a socket - by Wawoodman - 09-16-2012, 03:04 PM
RE: Mill, drill, and tap a socket - by Highpower - 09-16-2012, 03:08 PM
RE: Mill, drill, and tap a socket - by DaveH - 09-16-2012, 03:12 PM
RE: Mill, drill, and tap a socket - by stevec - 09-16-2012, 03:22 PM
RE: Mill, drill, and tap a socket - by Wawoodman - 09-16-2012, 04:07 PM
RE: Mill, drill, and tap a socket - by stevec - 09-16-2012, 04:19 PM
RE: Mill, drill, and tap a socket - by dalee - 09-16-2012, 07:30 PM
RE: Mill, drill, and tap a socket - by rleete - 09-18-2012, 06:40 AM



Users browsing this thread: 1 Guest(s)