09-15-2012, 07:46 AM
Hello Ed,
You might have a spindle bore of 1.57" but you unless you are intending to use it with that diameter stock I would design it to suit a 1.57" inch bore and then only bore it to the biggest size that I would be likely to use at the moment, that way if a big job turns up you can always bore it out to suit, but won't be wasting the time if that job never turns up.
Just my 2 pennies worth.
Regards
Rick
You might have a spindle bore of 1.57" but you unless you are intending to use it with that diameter stock I would design it to suit a 1.57" inch bore and then only bore it to the biggest size that I would be likely to use at the moment, that way if a big job turns up you can always bore it out to suit, but won't be wasting the time if that job never turns up.
Just my 2 pennies worth.
Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.