MetalworkingFun Forum › Machining › General Metalworking Discussion v
Drill Bits Ground For Brass

Thread Modes
Drill Bits Ground For Brass
sasquatch Offline
Senior
*****
Posts: 825
Threads: 25
Joined: Jul 2012
Location: N. Bay Ontario
#8
09-14-2012, 06:18 PM
I was going to suggest also, to buy a set of bits and grind them just for brass, if you use brass often.

Don't need a whole set, but buy whatever sizes you feel you use.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Drill Bits Ground For Brass - by EdK - 09-07-2012, 11:31 AM
RE: Drill Bits Ground For Brass - by rleete - 09-07-2012, 11:46 AM
RE: Drill Bits Ground For Brass - by TomG - 09-07-2012, 12:20 PM
RE: Drill Bits Ground For Brass - by DaveH - 09-07-2012, 12:53 PM
RE: Drill Bits Ground For Brass - by EdK - 09-07-2012, 01:22 PM
RE: Drill Bits Ground For Brass - by mikecwik - 09-07-2012, 07:53 PM
RE: Drill Bits Ground For Brass - by videoman - 09-07-2012, 10:55 PM
RE: Drill Bits Ground For Brass - by sasquatch - 09-14-2012, 06:18 PM
RE: Drill Bits Ground For Brass - by EdK - 09-14-2012, 06:30 PM



Users browsing this thread: 4 Guest(s)