|
Mill power feed
|
09-09-2012, 03:14 PM
Looking good Dalee, Is that torque limiter still operational? I was thinking it might come in handy in some instances.
Is the speed pot wired in place of the original drill trigger pot? Just curious. Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mill power feed - by dalee - 09-09-2012, 01:16 PM
RE: Mill power feed - by doubleboost - 09-09-2012, 02:36 PM
RE: Mill power feed - by stevec - 09-09-2012, 03:14 PM
RE: Mill power feed - by Highpower - 09-09-2012, 03:22 PM
RE: Mill power feed - by krv3000 - 09-09-2012, 05:45 PM
RE: Mill power feed - by dalee - 09-09-2012, 10:56 PM
RE: Mill power feed - by stevec - 09-10-2012, 06:29 AM
RE: Mill power feed - by dalee - 09-10-2012, 10:29 PM
|
