Running a shaper - the compound

[big job]

Im a little confused I cant figure out the 1/4" swing it should lift right
up to get the tool post out?? Clapping too much try putting a spring
on top I did that and get a much better snap.

(09-08-2012, 09:42 PM)Sunset Machine Wrote: Wait .. the deal's off. Would you guys believe that the clapper was clapping too hard? Seems so, anyway. Snugged the clapper locks up and then loosened 'em a bit. The clapper is limited to about 1/4" swing and things are looking stable...