MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lights For The Mill

Thread Modes
Lights For The Mill
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#2
09-07-2012, 04:34 PM
Ed
If there is an Ikea close these little lights are great. The flex part is threaded onto the base, I made little brackets and have them on the lathe and mill.
http://www.ikea.com/ca/en/catalog/products/20169658/
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Lights For The Mill - by EdK - 09-07-2012, 04:12 PM
RE: Lights For The Mill - by f350ca - 09-07-2012, 04:34 PM
RE: Lights For The Mill - by EdK - 09-07-2012, 04:44 PM
RE: Lights For The Mill - by claudef - 09-07-2012, 07:05 PM
RE: Lights For The Mill - by Highpower - 09-07-2012, 09:42 PM
RE: Lights For The Mill - by ETC57 - 09-19-2012, 09:35 AM
RE: Lights For The Mill - by Wawoodman - 09-07-2012, 11:59 PM
RE: Lights For The Mill - by Highpower - 09-19-2012, 04:17 PM
RE: Lights For The Mill - by NevadaBlue - 09-19-2012, 11:41 PM



Users browsing this thread: 2 Guest(s)