09-07-2012, 04:12 PM
I bought these two lights for $4 with a $4 rebate at the local home center. The bodies are made of aluminum and they are reasonably bright using LEDs rather than a light bulb. Some time ago I bought a few goose-necks that are normally used for microphones with the intent on using them to hold some lights for the mill. That time has arrived. These should work real slick for shining light on the workpiece as I'm milling it. The lights are only about 4" long and 7/8" in diameter and are powered by three AA batteries. I'll wire a power supply into them so I don't have to deal with the batteries. Not bad for almost 0$.
Ed
Ed