MetalworkingFun Forum › Machining › General Metalworking Discussion v
Drill Bits Ground For Brass

Thread Modes
Drill Bits Ground For Brass
rleete Offline
Senior
*****
Posts: 794
Threads: 52
Joined: Mar 2012
Location: Rochester, NY
#2
09-07-2012, 11:46 AM
There was a post on HMEM about it a while back. You simply grind off the front edge of the cutting edge square, if I remember correctly. The thread was pretty specific and included pics as I recall.
Full of ideas, but slow to produce parts
Reply
Thanks given by:


Messages In This Thread
Drill Bits Ground For Brass - by EdK - 09-07-2012, 11:31 AM
RE: Drill Bits Ground For Brass - by rleete - 09-07-2012, 11:46 AM
RE: Drill Bits Ground For Brass - by TomG - 09-07-2012, 12:20 PM
RE: Drill Bits Ground For Brass - by DaveH - 09-07-2012, 12:53 PM
RE: Drill Bits Ground For Brass - by EdK - 09-07-2012, 01:22 PM
RE: Drill Bits Ground For Brass - by mikecwik - 09-07-2012, 07:53 PM
RE: Drill Bits Ground For Brass - by videoman - 09-07-2012, 10:55 PM
RE: Drill Bits Ground For Brass - by sasquatch - 09-14-2012, 06:18 PM
RE: Drill Bits Ground For Brass - by EdK - 09-14-2012, 06:30 PM



Users browsing this thread: 1 Guest(s)