MetalworkingFun Forum › Machining › General Metalworking Discussion v
Sanders: metal or wood?

Thread Modes
Sanders: metal or wood?
SnailPowered Offline
Junior
****
Posts: 258
Threads: 13
Joined: Aug 2012
Location: USA
#5
09-04-2012, 11:13 AM
You can actually make thermite out of...other things than just rust. I would say clean the saw dust off as best you can before doing metal and I would think that you would be ok. Thumbsup
SnailPowered, proud to be a member of MetalworkingFun since Aug 2012.
Reply
Thanks given by:


Messages In This Thread
Sanders: metal or wood? - by Wawoodman - 09-04-2012, 09:28 AM
RE: Sanders: metal or wood? - by TomG - 09-04-2012, 10:31 AM
RE: Sanders: metal or wood? - by EdK - 09-04-2012, 10:38 AM
RE: Sanders: metal or wood? - by TomG - 09-04-2012, 10:57 AM
RE: Sanders: metal or wood? - by SnailPowered - 09-04-2012, 11:13 AM
RE: Sanders: metal or wood? - by doubleboost - 09-04-2012, 03:02 PM
RE: Sanders: metal or wood? - by EdK - 09-04-2012, 03:57 PM
RE: Sanders: metal or wood? - by Highpower - 09-04-2012, 08:06 PM
RE: Sanders: metal or wood? - by SnailPowered - 09-04-2012, 09:52 PM



Users browsing this thread: 1 Guest(s)