|
Deciding on a tool
|
09-04-2012, 11:09 AM
We always just referred to them as milling cutters along with a description. The one shown would be a straight tooth milling cutter.
Ed: I think shell mills normally have a key slot and counter-bored hole in them for mounting on a stub arbor. They are used more like an end mill. Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Deciding on a tool - by Wawoodman - 08-31-2012, 05:59 PM
RE: Deciding on a tool - by DaveH - 08-31-2012, 06:37 PM
RE: Deciding on a tool - by Wawoodman - 08-31-2012, 06:53 PM
RE: Deciding on a tool - by EdK - 08-31-2012, 07:13 PM
RE: Deciding on a tool - by f350ca - 08-31-2012, 07:14 PM
RE: Deciding on a tool - by Wawoodman - 08-31-2012, 09:35 PM
RE: Deciding on a tool - by DaveH - 08-31-2012, 07:33 PM
RE: Deciding on a tool - by TomG - 08-31-2012, 07:42 PM
RE: Deciding on a tool - by Wawoodman - 09-01-2012, 09:10 AM
RE: Deciding on a tool - by Highpower - 09-01-2012, 09:43 AM
RE: Deciding on a tool - by Wawoodman - 09-01-2012, 10:13 AM
RE: Deciding on a tool - by Highpower - 09-01-2012, 10:28 AM
RE: Deciding on a tool - by TomG - 09-01-2012, 11:36 AM
RE: Deciding on a tool - by PixMan - 09-03-2012, 10:24 PM
RE: Deciding on a tool - by Wawoodman - 09-04-2012, 09:16 AM
RE: Deciding on a tool - by EdK - 09-04-2012, 10:51 AM
RE: Deciding on a tool - by TomG - 09-04-2012, 11:09 AM
RE: Deciding on a tool - by EdK - 09-04-2012, 11:56 AM
RE: Deciding on a tool - by TomG - 09-04-2012, 12:20 PM
RE: Deciding on a tool - by EdK - 09-04-2012, 12:24 PM
RE: Deciding on a tool - by Mayhem - 09-05-2012, 04:48 AM
RE: Deciding on a tool - by TomG - 09-05-2012, 06:33 AM
RE: Deciding on a tool - by Mayhem - 09-05-2012, 06:39 AM
RE: Deciding on a tool - by PixMan - 09-07-2012, 08:36 PM
|
