09-04-2012, 08:48 AM
no expert but I would say the built in rake on the tool holder is pulling you in to the work. tool bit should be standing straight up and down.
you can silver solder a bit into a hunk of square bar, or mill a slot in it them silver solder or weld a cap on top and installed a set screw to make a quick and sometimes fancy tool holder, get rectangular bits long enough to use with by themselves
As Mayhem said pictures always help
you can silver solder a bit into a hunk of square bar, or mill a slot in it them silver solder or weld a cap on top and installed a set screw to make a quick and sometimes fancy tool holder, get rectangular bits long enough to use with by themselves
As Mayhem said pictures always help
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!