03-09-2012, 02:34 PM
Okay guys!!!
almost all the painting has been done and some small bits reassembled!!
I am not going to do the head yet as it seems to be in pretty good condition.
It will be a different colour and that might motivate me to get it done sooner...
I ordered new bearings for the hand cranked leadscrews and need to install them.
The old ones were a PIA to remove and required a bit of persuasion with Mr. Hammer.
What would be the best way to install the new bearings without damaging them?
Andrew
almost all the painting has been done and some small bits reassembled!!
I am not going to do the head yet as it seems to be in pretty good condition.
It will be a different colour and that might motivate me to get it done sooner...
I ordered new bearings for the hand cranked leadscrews and need to install them.
The old ones were a PIA to remove and required a bit of persuasion with Mr. Hammer.
What would be the best way to install the new bearings without damaging them?
Andrew
A proud member of MetalworkingFun Forum since Feb 2012.
1959 Myford ML7,1949 South Bend 9A,Clausing 8520 mill,Keller Die filer,1929 Rhodes Shaper.
1959 Myford ML7,1949 South Bend 9A,Clausing 8520 mill,Keller Die filer,1929 Rhodes Shaper.