RF-45 Downfeed Lock Knob

[EdK]

(09-03-2012, 07:19 PM)toolingjim Wrote: Nice work there. I did similar on my milldrill but used a 3/4" end mill for the finger scallops. I also added a thin plastic thrust washer under the knob when I noticed the metal knob was getting scraped up when I tightened it. By the way, I also built a quick adjusting handle at the same time to replace the three spoke handle that I wounded awhile ago. Worked out pretty well too.

OK Jim. Now you're committed. We need to see pictures of your mods. Please start a thread in the "Mills" section showing your mods. Please.

Thanks,
Ed