MetalworkingFun Forum › Machining › General Metalworking Discussion v
Reamers

Thread Modes
Reamers
bobm4360 Offline
Freshman
**
Posts: 32
Threads: 2
Joined: Jul 2012
Location: Oak Harbor, WA
#5
09-02-2012, 11:30 PM
With a chucking reamer, the tapered lead is very short, and easy to get through the workpiece. Using a hand reamer, it has to go farther through the work and you might have clearance issues. DAMHIKT. Using a hand reamer in the lathe, I usually feed the reamer with a tailstock center, very slow, lotsa lube.

Regards,
Bob
bobm4360, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Reamers - by Wawoodman - 09-02-2012, 10:49 AM
RE: Reamers - by stevec - 09-02-2012, 07:49 PM
RE: Reamers - by EdK - 09-02-2012, 08:03 PM
RE: Reamers - by Mayhem - 09-02-2012, 11:25 PM
RE: Reamers - by bobm4360 - 09-02-2012, 11:30 PM
RE: Reamers - by Wawoodman - 09-03-2012, 09:46 AM



Users browsing this thread: 1 Guest(s)