Single point threading problem
#19
And then there are a lot of us old timers that leave the compound right there at 29
for everything except taper turning. Then get or make a crossfeed thread stop,
that eases the burden. Then waiting for ever for the number I have that problem
and just live with it because I have an Atlas dial on a S.Bend cause I cant afford a
real one and the cause is, because the driven gear is like 24T and SBend needs 32T
however it does work for a Flea bay $10.00
big job, proud to be a member of MetalworkingFun since Jun 2012.
Reply
Thanks given by:


Messages In This Thread
Single point threading problem - by Mayhem - 07-30-2012, 05:57 AM
RE: Single point threading problem - by Highpower - 07-30-2012, 06:30 AM
RE: Single point threading problem - by Mayhem - 07-30-2012, 06:33 AM
RE: Single point threading problem - by Highpower - 07-30-2012, 06:36 AM
RE: Single point threading problem - by stevec - 07-30-2012, 06:54 AM
RE: Single point threading problem - by dallen - 07-30-2012, 07:42 AM
RE: Single point threading problem - by Mayhem - 07-30-2012, 07:52 AM
RE: Single point threading problem - by stevec - 07-30-2012, 01:40 PM
RE: Single point threading problem - by Mayhem - 09-01-2012, 10:44 PM
RE: Single point threading problem - by f350ca - 09-02-2012, 12:20 AM
RE: Single point threading problem - by Mayhem - 09-02-2012, 12:25 AM
RE: Single point threading problem - by big job - 09-02-2012, 05:31 AM
RE: Single point threading problem - by Mayhem - 09-02-2012, 05:37 AM
RE: Single point threading problem - by stevec - 09-02-2012, 07:26 AM
RE: Single point threading problem - by dallen - 09-02-2012, 07:48 AM
RE: Single point threading problem - by Mayhem - 08-05-2014, 07:01 AM
RE: Single point threading problem - by DaveH - 08-05-2014, 07:08 AM
RE: Single point threading problem - by Mayhem - 08-05-2014, 07:12 AM
RE: Single point threading problem - by stevec - 08-05-2014, 07:27 AM
RE: Single point threading problem - by awemawson - 08-05-2014, 07:31 AM
RE: Single point threading problem - by DaveH - 08-05-2014, 10:03 AM
RE: Single point threading problem - by EdK - 08-05-2014, 11:42 AM
RE: Single point threading problem - by EdK - 08-05-2014, 11:46 AM
RE: Single point threading problem - by stevec - 08-05-2014, 02:33 PM
RE: Single point threading problem - by f350ca - 08-05-2014, 04:55 PM
RE: Single point threading problem - by stevec - 08-05-2014, 05:59 PM



Users browsing this thread: 1 Guest(s)