MetalworkingFun Forum › Machining › General Metalworking Discussion v
Single point threading problem

Thread Modes
Single point threading problem
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#18
09-02-2012, 12:25 AM
(09-02-2012, 12:20 AM)f350ca Wrote: ...That depth on the cross feed is your new setting as you back out and return for subsequent passes.

I think that is where I messed up.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Single point threading problem - by Mayhem - 07-30-2012, 05:57 AM
RE: Single point threading problem - by Highpower - 07-30-2012, 06:30 AM
RE: Single point threading problem - by Mayhem - 07-30-2012, 06:33 AM
RE: Single point threading problem - by Highpower - 07-30-2012, 06:36 AM
RE: Single point threading problem - by stevec - 07-30-2012, 06:54 AM
RE: Single point threading problem - by dallen - 07-30-2012, 07:42 AM
RE: Single point threading problem - by Mayhem - 07-30-2012, 07:52 AM
RE: Single point threading problem - by stevec - 07-30-2012, 01:40 PM
RE: Single point threading problem - by Mayhem - 09-01-2012, 10:44 PM
RE: Single point threading problem - by f350ca - 09-02-2012, 12:20 AM
RE: Single point threading problem - by Mayhem - 09-02-2012, 12:25 AM
RE: Single point threading problem - by big job - 09-02-2012, 05:31 AM
RE: Single point threading problem - by Mayhem - 09-02-2012, 05:37 AM
RE: Single point threading problem - by stevec - 09-02-2012, 07:26 AM
RE: Single point threading problem - by dallen - 09-02-2012, 07:48 AM
RE: Single point threading problem - by Mayhem - 08-05-2014, 07:01 AM
RE: Single point threading problem - by DaveH - 08-05-2014, 07:08 AM
RE: Single point threading problem - by Mayhem - 08-05-2014, 07:12 AM
RE: Single point threading problem - by stevec - 08-05-2014, 07:27 AM
RE: Single point threading problem - by awemawson - 08-05-2014, 07:31 AM
RE: Single point threading problem - by DaveH - 08-05-2014, 10:03 AM
RE: Single point threading problem - by EdK - 08-05-2014, 11:42 AM
RE: Single point threading problem - by EdK - 08-05-2014, 11:46 AM
RE: Single point threading problem - by stevec - 08-05-2014, 02:33 PM
RE: Single point threading problem - by f350ca - 08-05-2014, 04:55 PM
RE: Single point threading problem - by stevec - 08-05-2014, 05:59 PM



Users browsing this thread: 4 Guest(s)