MetalworkingFun Forum › Machinery › Milling Machines v
Deciding on a tool

Thread Modes
Deciding on a tool
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#14
09-01-2012, 11:36 AM
Yes, pictures are good.

Here's what I was referring to about side cutting vs. end cutting (or center cutting) end mills.

Tom

[Image: 41IaA7j-TzL.jpg]

[Image: 82576_R.jpg]
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Deciding on a tool - by Wawoodman - 08-31-2012, 05:59 PM
RE: Deciding on a tool - by DaveH - 08-31-2012, 06:37 PM
RE: Deciding on a tool - by Wawoodman - 08-31-2012, 06:53 PM
RE: Deciding on a tool - by EdK - 08-31-2012, 07:13 PM
RE: Deciding on a tool - by f350ca - 08-31-2012, 07:14 PM
RE: Deciding on a tool - by Wawoodman - 08-31-2012, 09:35 PM
RE: Deciding on a tool - by DaveH - 08-31-2012, 07:33 PM
RE: Deciding on a tool - by TomG - 08-31-2012, 07:42 PM
RE: Deciding on a tool - by Wawoodman - 09-01-2012, 09:10 AM
RE: Deciding on a tool - by Highpower - 09-01-2012, 09:43 AM
RE: Deciding on a tool - by Wawoodman - 09-01-2012, 10:13 AM
RE: Deciding on a tool - by Highpower - 09-01-2012, 10:28 AM
RE: Deciding on a tool - by TomG - 09-01-2012, 11:36 AM
RE: Deciding on a tool - by PixMan - 09-03-2012, 10:24 PM
RE: Deciding on a tool - by Wawoodman - 09-04-2012, 09:16 AM
RE: Deciding on a tool - by EdK - 09-04-2012, 10:51 AM
RE: Deciding on a tool - by TomG - 09-04-2012, 11:09 AM
RE: Deciding on a tool - by EdK - 09-04-2012, 11:56 AM
RE: Deciding on a tool - by TomG - 09-04-2012, 12:20 PM
RE: Deciding on a tool - by EdK - 09-04-2012, 12:24 PM
RE: Deciding on a tool - by Mayhem - 09-05-2012, 04:48 AM
RE: Deciding on a tool - by TomG - 09-05-2012, 06:33 AM
RE: Deciding on a tool - by Mayhem - 09-05-2012, 06:39 AM
RE: Deciding on a tool - by PixMan - 09-07-2012, 08:36 PM



Users browsing this thread: 2 Guest(s)