03-08-2012, 06:02 PM
(03-08-2012, 05:57 PM)EdAK Wrote: John,
That's a good idea to mill the large insert tool holders to fit right on the tool post.
The tool holders didn't warp when you heated them?
Ed
Hi
Ed
No they were ok
I did have to clean the threads up
All i did was take the temper out of them
The tool holders were useless to me without doing this
I tried a large tool holder for them but i had issues with centre height & rigidity
All they cost was a dove tail cutter and some gas
John