|
Deciding on a tool
|
08-31-2012, 06:37 PM
(08-31-2012, 05:59 PM)Wawoodman Wrote: The slot will be 1/4 inch wide, and 1/4 inch deep. Which would be a better choice: an end mill, or a side cutting mill? If an end mill, should I use a small one, like 3/8, or a large one,Hi Woodman, I am a little confused - are you wanting to cut a slot ? -like a key way?  DaveH |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Deciding on a tool - by Wawoodman - 08-31-2012, 05:59 PM
RE: Deciding on a tool - by DaveH - 08-31-2012, 06:37 PM
RE: Deciding on a tool - by Wawoodman - 08-31-2012, 06:53 PM
RE: Deciding on a tool - by EdK - 08-31-2012, 07:13 PM
RE: Deciding on a tool - by f350ca - 08-31-2012, 07:14 PM
RE: Deciding on a tool - by Wawoodman - 08-31-2012, 09:35 PM
RE: Deciding on a tool - by DaveH - 08-31-2012, 07:33 PM
RE: Deciding on a tool - by TomG - 08-31-2012, 07:42 PM
RE: Deciding on a tool - by Wawoodman - 09-01-2012, 09:10 AM
RE: Deciding on a tool - by Highpower - 09-01-2012, 09:43 AM
RE: Deciding on a tool - by Wawoodman - 09-01-2012, 10:13 AM
RE: Deciding on a tool - by Highpower - 09-01-2012, 10:28 AM
RE: Deciding on a tool - by TomG - 09-01-2012, 11:36 AM
RE: Deciding on a tool - by PixMan - 09-03-2012, 10:24 PM
RE: Deciding on a tool - by Wawoodman - 09-04-2012, 09:16 AM
RE: Deciding on a tool - by EdK - 09-04-2012, 10:51 AM
RE: Deciding on a tool - by TomG - 09-04-2012, 11:09 AM
RE: Deciding on a tool - by EdK - 09-04-2012, 11:56 AM
RE: Deciding on a tool - by TomG - 09-04-2012, 12:20 PM
RE: Deciding on a tool - by EdK - 09-04-2012, 12:24 PM
RE: Deciding on a tool - by Mayhem - 09-05-2012, 04:48 AM
RE: Deciding on a tool - by TomG - 09-05-2012, 06:33 AM
RE: Deciding on a tool - by Mayhem - 09-05-2012, 06:39 AM
RE: Deciding on a tool - by PixMan - 09-07-2012, 08:36 PM
|
