MetalworkingFun Forum › Machining › General Metalworking Discussion v
Digital Protractor

Thread Modes
Digital Protractor
Wawoodman
Unregistered
 
#11
08-31-2012, 01:48 PM
So, I'm a little confused. Does it have a 0 setting to start from, in case your mill vise isn't level?

EDIT: Never mind. I answered my own question, and ordered one!
Reply
Thanks given by:


Messages In This Thread
Digital Protractor - by TOM REED - 08-30-2012, 11:09 AM
RE: DIGITAL PROTRACTOR - by Highpower - 08-30-2012, 02:13 PM
RE: DIGITAL PROTRACTOR - by EdK - 08-30-2012, 03:43 PM
RE: DIGITAL PROTRACTOR - by doubleboost - 08-30-2012, 04:47 PM
RE: DIGITAL PROTRACTOR - by stevec - 08-30-2012, 06:49 PM
RE: DIGITAL PROTRACTOR - by EdK - 08-30-2012, 07:41 PM
RE: DIGITAL PROTRACTOR - by TOM REED - 08-30-2012, 08:37 PM
RE: DIGITAL PROTRACTOR - by EdK - 08-31-2012, 09:26 AM
RE: DIGITAL PROTRACTOR - by ETC57 - 08-31-2012, 10:18 AM
RE: DIGITAL PROTRACTOR - by Highpower - 08-31-2012, 11:09 AM
RE: DIGITAL PROTRACTOR - by Wawoodman - 08-31-2012, 01:48 PM
RE: DIGITAL PROTRACTOR - by pineyfolks - 08-31-2012, 02:01 PM
RE: DIGITAL PROTRACTOR - by Highpower - 08-31-2012, 03:19 PM
RE: DIGITAL PROTRACTOR - by EdK - 08-31-2012, 03:21 PM
RE: DIGITAL PROTRACTOR - by f350ca - 08-31-2012, 02:38 PM
RE: DIGITAL PROTRACTOR - by Wawoodman - 08-31-2012, 05:06 PM
RE: DIGITAL PROTRACTOR - by Highpower - 08-31-2012, 03:26 PM
RE: DIGITAL PROTRACTOR - by SnailPowered - 08-31-2012, 04:23 PM
RE: DIGITAL PROTRACTOR - by Wawoodman - 08-31-2012, 04:53 PM
RE: DIGITAL PROTRACTOR - by f350ca - 08-31-2012, 07:19 PM
RE: DIGITAL PROTRACTOR - by f350ca - 08-31-2012, 07:21 PM
RE: DIGITAL PROTRACTOR - by sasquatch - 08-31-2012, 07:23 PM
RE: DIGITAL PROTRACTOR - by stevec - 09-01-2012, 07:16 AM
RE: DIGITAL PROTRACTOR - by TOM REED - 09-01-2012, 11:29 AM
RE: DIGITAL PROTRACTOR - by EdK - 09-01-2012, 12:57 PM



Users browsing this thread: 2 Guest(s)