Latest Delivery
(05-17-2023, 05:16 PM)EdK Wrote:
(05-17-2023, 04:22 PM)Highpower Wrote:
(05-17-2023, 03:57 PM)rleete Wrote: I am pleased with this purchase, and wish I had gotten it years ago.

Exactly what I said after I bought mine. When you need one they are worth their weight in gold.

I would love to get a set but having no press of any kind would make it useless for me.  Bash

Ed

For small broaches like that, I just use the quill on my mill to push them through. It doesn't take much.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: EdK
I bought a HF arbor press many years ago for a project that never happened. It took longer to clean the decades of crud off it that it took to press the broach through.

But I think for sizes that small, a drill press would be more than enough.
Full of ideas, but slow to produce parts
Reply
Thanks given by: EdK
(05-18-2023, 07:44 AM)rleete Wrote: I bought a HF arbor press many years ago for a project that never happened.  It took longer to clean the decades of crud off it that it took to press the broach through.

But I think for sizes that small, a drill press would be more than enough.

I'm blaming you and Tom, I ordered the broach set. Big Grin

Ed
Reply
Thanks given by:
(05-18-2023, 10:22 AM)EdK Wrote: I'm blaming you and Tom, I ordered the broach set.  Big Grin

Ed

Hold that thought Ed. Big Grin
Willie
Reply
Thanks given by:
I'm blaming you (again) EdK.  Big Grin

   
Willie
Reply
Thanks given by:
You Suck
Reply
Thanks given by:
(05-17-2023, 03:57 PM)rleete Wrote: I've been wanting some broaches for a long time, and I finally bit the bullet and got some.  Seller is discount_machine, on eBay.  It pictured a plain wooden box, but the one that showed up is this fancy case as shown:



Inside is nice, too:



And after just a few minutes with the arbor press, this is the result:



Cutters are very sharp, and all the parts appear very well made.  1/2" bushing was a nice slip fit in the 1/2" bore of the part.  Since the bushing and shim are both shorter than the part, I ran it through from both ends.  I am pleased with this purchase, and wish I had gotten it years ago.

So much easier than doing it on a lathe or in a shaper.  Smiley-signs107
Reply
Thanks given by:
Got the broach set along with a chunk of brass I need for a future project. Both from ebay.

Ed

   
Reply
Thanks given by:
Copycat.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
(05-22-2023, 06:25 AM)rleete Wrote: Copycat.

Wow. Rough crowd. smiley_laughing
Willie
Reply
Thanks given by:




Users browsing this thread: 18 Guest(s)