07-07-2012, 07:51 PM
hi all just sum pics of sum of the things i did for engine No10
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
engine No10
|
07-07-2012, 07:51 PM
hi all just sum pics of sum of the things i did for engine No10
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
07-07-2012, 08:02 PM
Hi Bob,
Good work. Can you give a bit more info on the picture where you are turning between centres please? I'd like a better look at your drive set up.
Hunting American dentists since 2015.
07-07-2012, 08:25 PM
hi no problem when you get a compact 8 from new their is no face plate Wat you get is a drive pin that goes in to one of the fixing holes for the chuck and you use that to drive a lathe dog well i don't have any lathe dog's their on me too do list with a drive pin so to drive the con rod that's the bit bin made i made a post out of sum scrap ally drilled the bottom and tap it m8 and fitted a m8 stud then on top of that i made up a u shape to be a snug fit over the bottom end of the con rod. that was fit ed to the top of the post by a m6 cap Heda if i still have it i will get a pic of it for you but her is sum pics of the crank bin machined up in the same way
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
07-07-2012, 08:45 PM
Thanks Bob, I figured that was what you were doing but wasn't entirely sure. May have to do something similar for my mate's 9" lathe.
Hunting American dentists since 2015.
|
« Next Oldest | Next Newest »
|