Posts: 2,608
Threads: 99
Joined: Dec 2014
Location: Michigan
What is the thinnist piece of metal an ER40 will hold so you can face it? It will be 25mm diameter, will it hold a 2mm thick disk with some sticking out to face it? The material will actually be brass. I don't have the collet or chuck yet so I can't check myself.
Posts: 8,842
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
Couldn't you put a 25mm stub behind the disk to support it in the collet? Kind of as a stop for the disk.
Ed
Posts: 2,608
Threads: 99
Joined: Dec 2014
Location: Michigan
Yeah, that thought had crossed my mind, just wasn't sure if there would still be enough for the ER to hold onto it.
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
Don't bore out the whole ER to 25MM. Instead cut it like a counterbore with a bottom as the stop.
Posts: 4,438
Threads: 183
Joined: Feb 2012
Location: Missouri, USA
The following 2 users Like Highpower's post:
EdK (02-07-2023), f350ca (02-08-2023)
Posts: 2,608
Threads: 99
Joined: Dec 2014
Location: Michigan
The following 1 user Likes Vinny's post:
EdK (02-07-2023)
(02-07-2023, 11:45 AM)Highpower Wrote:
I see I have a project in my very very near future!
Thanks!!!
Posts: 8,842
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
Highpower (02-07-2023)
Looks like a type of pot chuck. I've made them for my lathe when I need to hold something thin.
Ed
Posts: 4,438
Threads: 183
Joined: Feb 2012
Location: Missouri, USA
The following 1 user Likes Highpower's post:
EdK (02-07-2023)
For just facing thin material I've had luck with facing off the end of a piece of bar stock in the chuck and super gluing the thin part to the end of it. Just take light cuts. A little heat or Acetone will remove the super glue afterward. Or use double stick (carpet) tape. If I needed to do a
bunch of parts though, I would go with the collet fixture.
Willie
Posts: 2,608
Threads: 99
Joined: Dec 2014
Location: Michigan
The following 2 users Like Vinny's post:
Highpower (02-08-2023), arvidj (02-10-2023)
It'll hafta be the collet fixture, there will be over 100 of them.
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
The following 1 user Likes Dr Stan's post:
rleete (02-10-2023)
and there will be pics of course