HF Bandsaw Dimension

Pages (2): « Previous 1 2

Thread Modes

HF Bandsaw Dimension

Highpower Offline

JAFO

Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA

#11

12-24-2021, 02:15 PM

Well don't think you are the lone ranger Ed. I'm in the same boat with the half-finished projects club.

Retire they said, and you'll be bored out of your mind with nothing to do they said. HA! I don't have the time to be bored if I wanted to! Sad

Willie

Like Post

Thanks given by: EdK

Vinny

Another Whipping Boy

Posts: 2,620
Threads: 100
Joined: Dec 2014
Location: Michigan

#12

12-24-2021, 02:23 PM

You guys aren't alone. I still have an antenna here I haven't finished yet. But that's ok, the tower isn't up either.

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

Thanks given by: EdK

EdK

Whipping Boy

Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

The following 4 users Like EdK's post:
f350ca (01-19-2022), Highpower (01-19-2022), vtsteam (01-19-2022), arvidj (01-19-2022)

#13

01-19-2022, 03:38 PM

My band saw went on its maiden voyage today and did a superb job. Smooth and quite. I needed to cut a 1.5" piece off of a 2.18" x 1.75" x 12" piece of 1018 for a spacer block for my QCTP on my mini lathe. See surface finish below. I used a wax based cutting lube which I've used in the past when I had my other 4x6 band saw.

Ed

Like Post

vtsteam Offline

Sophmore

Posts: 205
Threads: 3
Joined: Jul 2014
Location: Vermont

#14

01-19-2022, 09:24 PM

Very nice, indeed!

Man my HF bandsaw needed a LOT "adjustment" (well, modification) to cut straight and square. But maybe they are making them better now than they did.

http://www.youtube.com/c/SRHacksaw

Like Post

EdK

Whipping Boy

Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

#15

01-19-2022, 11:34 PM

(01-19-2022, 09:24 PM)vtsteam Wrote: But maybe they are making them better now than they did.

I think they are. I'm pretty impressed with the quality of the one I got.

Ed

Like Post

EdK

Whipping Boy

Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

The following 4 users Like EdK's post:
Highpower (03-04-2022), f350ca (03-04-2022), JScott (03-04-2022), arvidj (03-05-2022)

#16

03-04-2022, 02:11 PM

I had to cut a bunch of aluminum pieces for a future project, when the mill arrives. I had added the tray underneath to catch most of the swarf but it was still getting on the floor so I clamped a piece of 3D printed part that was a reject from some project to see if it would help block some of the swarf. It did so I'm going to take some measurements and print up a proper shield.

Ed