01-30-2020, 10:18 PM
(01-30-2020, 08:17 PM)Dr Stan Wrote: Sounds like someone has a construction project in his future.
Only if there is a winning lottery ticket in his future before hand.
Willie
|
Latest Delivery
|
|
Only if there is a winning lottery ticket in his future before hand. 
01-31-2020, 11:36 PM
(01-30-2020, 10:18 PM)Highpower Wrote:(01-30-2020, 08:17 PM)Dr Stan Wrote: Sounds like someone has a construction project in his future. 
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique 
02-01-2020, 06:54 AM
Looks like you really scored on that mill Stan. Unloading a new machine is always something of an adventure.
Lathe (n); a machine tool used in the production of milling machine components.
Milling Machine (n); a machine tool used in the production of lathe components. 
02-01-2020, 12:35 PM
Had to go to Evansville IN to rent machine skates. Several of the tool rental houses I called didn't even know what they are.
 Taking it slow and easy. Don't want 6K lbs getting away from me. 
02-01-2020, 06:24 PM
Well it's finally up on the skates. Had some trouble with my porta-power. When I finally got that straightened out everything went according to plan. It's ready to move on some plywood sheets I have laid out and my neighbor has a 4 wheeler with a 5K winch on the front. He's going to help me move it to the shop tomorrow.
I'll tell you what, I know I bit off more than I can chew 4 weeks after knee joint replacement surgery. However that's how I will regain full range of motion. Yesterday at therapy I bent it to 99 degrees. I couldn't repeat that and it hurt like a !*#&*, the best I could do again was 97 degrees. The thing was the seller was motivated. The first one to show up with $350 would be the new owner. I knew I couldn't get hurt on the purchase as it is worth at least that much in scrap. Well such is the life of mice & men. Fortunately no one nor anything was damaged. As one can see it is now sitting in the shop where I can get to it when time allows.
02-04-2020, 09:56 PM
Congratulations!!
How is not important ... done is!! 
02-04-2020, 10:21 PM
On the bright side, it could have been worse. At least it wasn't on concrete and it picked the lesser of two evils when it chose to roll onto the right side instead of the left. (Hand wheel, electrical switches...)
Looking at the mass of that thing I could tell a little bit of sod wasn't going to have hurt anything anyway. 
Willie
|
|
« Next Oldest | Next Newest »
|
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)
Users browsing this thread: 12 Guest(s)