MetalworkingFun Forum › Machining › Metrology v
rev cawnter refit

Thread Modes
rev cawnter refit
krv3000 Offline
Senior
*****
Posts: 1,520
Threads: 157
Joined: Feb 2012
Location: uk
The following 2 users Like krv3000's post:
Highpower (11-27-2017), Mayhem (11-27-2017)
#1
11-26-2017, 05:54 PM
hi I got this of john it was in a poor state it needed a full strip dawn the box to was well hammered so gave it my loving touch I have tried all over the place to get the type of fabric covering that goes on this type of box with no success any way pics


Attached Files Thumbnail(s)
                                   
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
krv3000 Offline
Senior
*****
Posts: 1,520
Threads: 157
Joined: Feb 2012
Location: uk
The following 4 users Like krv3000's post:
f350ca (11-26-2017), Highpower (11-27-2017), EdK (11-27-2017), Mike E. (11-27-2017)
#2
11-26-2017, 05:56 PM
more pics


Attached Files Thumbnail(s)
               
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
Mike E. Offline
Sophmore
***
Posts: 239
Threads: 2
Joined: Sep 2016
Location: California & Wales Home & Home Away
#3
11-27-2017, 04:38 PM
Nice restoration job ! Just judging by the photos, the original box covering looks like the material that is used on guitar amplifiers.
Mike
Reply
Thanks given by:
krv3000 Offline
Senior
*****
Posts: 1,520
Threads: 157
Joined: Feb 2012
Location: uk
#4
11-28-2017, 04:38 PM
ooo I will have to have a look
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
Highpower Offline
JAFO
******
Posts: 4,443
Threads: 183
Joined: Feb 2012
Location: Missouri, USA
The following 1 user Likes Highpower's post:
Mike E. (12-03-2017)
#5
11-28-2017, 10:01 PM
That material looks similar to the textured vinyl fabric that is covering a range box I have.   Chin

   
Willie
Reply
Thanks given by:
krv3000 Offline
Senior
*****
Posts: 1,520
Threads: 157
Joined: Feb 2012
Location: uk
#6
11-29-2017, 05:43 PM
yep its all so on mice boxes
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)