11-21-2017, 10:01 PM
These are pics of the Shahe DRO I fitted to my lathe. The lathe is a Optimum Maschinen 280 x 600. Of course the longitudinal feed is more like 500mm so I fitted a 500mm length DRO.
The only parts I had to manufacture were spacers to fit behind the standard clamps, a coolant splash guard and a reader bracket which is attached to the carriage. This bracket is in two pieces, I opted to run the bracket below the DRO and then up to the reader so as to stop coolant dribbling down the bracket and onto the reader and bar.
The only parts I had to manufacture were spacers to fit behind the standard clamps, a coolant splash guard and a reader bracket which is attached to the carriage. This bracket is in two pieces, I opted to run the bracket below the DRO and then up to the reader so as to stop coolant dribbling down the bracket and onto the reader and bar.