11-09-2015, 03:25 PM
lol I meant rost chestnuts
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Coke Forge Build
|
11-09-2015, 03:25 PM
lol I meant rost chestnuts
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
11-09-2015, 06:08 PM
So, do you guys know the difference between beer nuts and deer nuts?
Wait for it... Beer nuts are $1.29. Deer nuts are under a buck.
Mike
SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
11-10-2015, 06:04 PM
lol
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
11-14-2015, 12:02 PM
11-14-2015, 01:04 PM
Rob,
Does that lever adjust the amount of air into the forge? Ed
11-14-2015, 01:59 PM
Thanks given by: EdK
11-15-2015, 01:10 PM
And a wee bit more done
I remembered that I had not finished the motor/fan mount , so added a cross member and a rubber mount . The rubber foot just sits on the cross member so the unit is free to float . Then I decided I would do something with the ash dump , I cut a section out of the tube and re welded it ,I also turned down the flange . With the end being angled forwards it gives more room for a bucket , just need to come up with a flappy thing to cover the end . Rob |
« Next Oldest | Next Newest »
|