|
OTMT mini mill
|
07-31-2015, 11:05 AM
Just bought a used mini mill, I seem to remember seeing a mini mill with a dial indicator rigged to measure the down feed of the spindle, but can't find any info now on the internet.
Does anyone have photos of this? Thanks
7mag, proud to be a member of MetalworkingFun Forum since Nov 2013.
07-31-2015, 01:03 PM
I have a dial gauge on my RF mill. Not sure if it will help you.
 DaveH 
08-01-2015, 08:00 AM
I just use a dial indicator mounted upside down in one of these:
http://www.ebay.com/itm/Mighty-Mag-Unive...19f173028d I use the magnet to attach it to the column and have the point against the spindle housing.
Charles Spencer, proud to be a member of MetalworkingFun Forum since Aug 2014.
08-24-2015, 06:25 PM
I was using my mini mill today and remembered this topic. I've attached a picture of my dial indicator on the mill:
Charles Spencer, proud to be a member of MetalworkingFun Forum since Aug 2014.
|
|
« Next Oldest | Next Newest »
|
