What material to use for geared shaft
#21
(06-14-2015, 05:34 AM)Mayhem Wrote: Pete - my comments were totally tongue in cheek,

Yeah don't worry Darren, I picked up on that. Big Grin
I'm a bit blown away by Ken's generous offer, being such a newbie around here.
BTW, haven't heard much about your behemoth lathe for a while...
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:
#22
(06-14-2015, 06:05 AM)Pete O Wrote: ...BTW, haven't heard much about your behemoth lathe for a while...

I've aggravated an old injury, so have been limited on what I can do. I did manage to pull the wire from the motor today and run new wire but ran out of time to finish it off.
Hunting American dentists since 2015.
Reply
Thanks given by:
#23
(06-14-2015, 06:05 AM)Pete O Wrote:
(06-14-2015, 05:34 AM)Mayhem Wrote: Pete - my comments were totally tongue in cheek,

Yeah don't worry Darren, I picked up on that. Big Grin
I'm a bit blown away by Ken's generous offer, being such a newbie around here.
BTW, haven't heard much about your behemoth lathe for a while...

The offer is valid, and real, Pete.

I would enjoy carving away a pile of steel or cast iron, whichever you'd prefer. Or, get someone there to make a steel weldment box that just needs some finishing.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)