Stock racks...what do you use?
(05-20-2015, 05:25 PM)EdK Wrote: Give us a clue. Is it on the upper half or the lower half of the rack?
Upper half.
Ed

I've given you a clue Popcorn - it is not on Ken's or Darren's rack. Therefore is must be something to do with the part that I added to the back.
Something to do with how the rack holds the metal.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
(05-20-2015, 05:27 PM)DaveH Wrote:
(05-20-2015, 05:21 PM)EdK Wrote: With the white and black you could make zebra stripes.

Ed

Mmm ........... tricky ........... is that black stripes on white or white stripes on black. Cool
Smiley-eatdrink004
DaveH

yes
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
Plus I said I can change it quite easily. One operation say four times.
Some times errors like this are politely called "built in redundancy"
Smiley-eatdrink004 
DaveH 
Reply
Thanks given by:
The very top back does not have the horizontal dividers sticking back to support the stock from falling out the side?

Ed
Reply
Thanks given by:
If I show the corrected drawing you will just compare and say "ah those bit(s)"  Big Grin 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
(05-20-2015, 05:44 PM)EdK Wrote: The very top back does not have the horizontal dividers sticking back to support the stock from falling out the side?

Ed

Considering you don't have a rack that is pretty damn good - it's wrong but still Rotfl you are on the right track.
The initial design for me was that it should be capable of supporting 3 meter lengths but only on one side. The other side will only support  lengths up to 1.8 meters, so I don't need the top support on the back.
Yikes you are close. Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
I even did this with a 1.8 meter long piece of metal in the rack and I still didn't see it.
   

Rotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
This shows it better
   

Bash
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
I can see it but  can't put it in words. Blush 

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
Corrected CAD drawing
   
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)