03-10-2015, 05:15 PM
|
Billy G's Die Filer
|
03-10-2015, 05:44 PM
(This post was last modified: 03-10-2015, 05:45 PM by Bill Gruby.)
Dave. I marked the Trunnion and parts on this drawing. Let me know if it helps you? Click on the picture, it gets a little bigger.
"Billy G" 
03-10-2015, 06:31 PM
Billy,
Perfect   DaveH 
03-10-2015, 06:49 PM
I have been working with this one for a few months now Dave, There are times when I take it for granted that everyone sees what I see. Please, all of you, feel free to stop me anytime with your question. I see this project in my sleep.
"Billy G"
03-10-2015, 07:02 PM
I think the two yoke guides are too close together the inside vertical faces measure 2.75" apart. If the yoke dimensions remain as they are the two inside vertical faces of the yoke guides need to be 3" apart.
I could be misreading the drawings.  DaveH
03-10-2015, 07:10 PM
(This post was last modified: 03-10-2015, 07:19 PM by Bill Gruby.)
On my drawing, the one I just gave you, they are 3 inches apart. I just looked at the revision 3 print of the back and the 3.750 dimension should be 4.000. That will place the guides 3 inches apart. That is the di8mension of the mounting holes for the guides Ed.
Nice catch Dave. I was going to start doing all those holes tomorrow "Billy G"
03-10-2015, 07:39 PM
(This post was last modified: 03-10-2015, 07:41 PM by Bill Gruby.)
#1, the stroke is only 2 inches. By re-spacing the mounting holes to 4.000 inches the vertical faces will be 3 inches. It will be fine Dave with the 3 inch space.
"Billy G"  (03-10-2015, 05:44 PM)Bill Gruby Wrote: Dave. I marked the Trunnion and parts on this drawing. Let me know if it helps you? Click on the picture, it gets a little bigger. I'm following this project closely. You are making great progress, very interesting. Great picture of you and your helpers toesin post #92.  I have a shop helper at times too
03-11-2015, 05:38 AM
(03-10-2015, 07:10 PM)Bill Gruby Wrote: On my drawing, the one I just gave you, they are 3 inches apart. I just looked at the revision 3 print of the back and the 3.750 dimension should be 4.000. That will place the guides 3 inches apart. That is the di8mension of the mounting holes for the guides Ed. Does this look correct now? Ed
03-11-2015, 07:23 AM
Yes Ed. Looks good to go.
I'm having a little trouble with the slot. I am going to cut one today so that I can better see what it looks like. "Billy G" |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 35 Guest(s)