Let's see your bandsaw
#11
Willie,

That's a nice size band saw for a home shop. The 5x6 I have is too small at times so I have to get a little creative.

Ed
Reply
Thanks given by:
#12
Willie,

Nice bandsaw - good size

DaveH
Reply
Thanks given by:
#13
This is something that may be of interest to the 4x6 owners.

Mini saw table
Willie
Reply
Thanks given by:
#14
Hay!!

Finley I've got pics! Big Grin

So here's my $50.00 band saw, I supplied the blade, light, and the 6"sq table.Cool

Jerry.
So what am I dooing wrong wheres my picBash
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#15
Jerry,

Once you've browsed to your picture and selected it are you clicking on the "Add Attachment" button?

Ed

   
Reply
Thanks given by:
#16

I am now Ed,

But once again I have run into the dreaded (your pics are too biggg ) I keep forgetting how big all my old pics are so will work on reducing them.BlushSlapheadPcwhack

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#17
Jerry,

One of the easy ways to reduce the size, is to use the photo software to "Email"
Click the photo's you want to post, then click "Email" the software will reduce the size and open an email page with your photo's shown as attachments in the email.
You can click and drag (or copy) each photo (attachment) to your desk top, or to a folder.

Your ready to post.
Smiley-eatdrink004
Dave
Reply
Thanks given by:
#18
I use GIMP to re-size my pictures. It's free, open source software and easy to use once you've played with it a bit.

http://www.gimp.org/downloads/

Ed
Reply
Thanks given by:
#19
    Here we go againSweat
[attchment=157]
Hay lookie what I did!Big Grin
By golly I'll get the hang of these new fangled contraptions yetCool
Jerry.Popcorn



Attached Files Thumbnail(s)
   
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#20
OK so I still need to figure out how to place pics where I want them, but I did figure out how to make them smaller!!!Big GrinBig GrinBig Grin

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)