12-27-2014, 12:08 PM
Bench Master Power Hack Saw
|
12-27-2014, 08:52 PM
Noah may have had one like that John. I'll see if I can locate his email address. I just need to find my stone tablet business card index
![]() Seriously, that is a very robust saw. Most of us would love the chunk of bar stock being used as the feed weight.
Hunting American dentists since 2015.
12-28-2014, 08:11 AM
John, that's a nifty looking tire in the right hand background, is it from a similar vintage unicycle?
![]() Steve ![]()
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
12-29-2014, 07:35 PM
(12-28-2014, 08:11 AM)stevec Wrote: John, that's a nifty looking tire in the right hand background, is it from a similar vintage unicycle?I'd have to say that tyre (a.k.a. tire) in the background is probably closely related to the other one on the opposite end of the axle. ![]() John, Can you get some close-up photos of the area where the missing part would be? We could collectively come up with a reverse engineered design for it.
I've got one of those, it's tucked away in storage at the minute, will see if I can dig it out and take
some pics. I sold it on fleabay a while back and then had a mishap getting it out of the van at home.....snapped the blade arm casting clean in two ![]() even less impressed as he'd driven 70 miles to collect the bloody thing ![]()
alspeed, proud to be a member of MetalworkingFun Forum since Jan 2014.
01-02-2015, 09:32 AM
alspeed, proud to be a member of MetalworkingFun Forum since Jan 2014.
01-02-2015, 12:09 PM
Three posts and you've already mastered pictures. There will be no stopping you now alspeed!
I'm sure John will have that saw up and running in no time as a result.
Hunting American dentists since 2015.
01-02-2015, 01:04 PM
(This post was last modified: 01-02-2015, 01:05 PM by the penguin.)
I have a 40s era, 4" x 4" Keller power hacksaw in storage, its fun to watch, but slower than hell, to get a good cut on a 3" stock, it takes about 25 minutes.
jack
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)