MetalworkingFun Forum › Machining › General Metalworking Discussion v
Before and after, drill press vise.

Thread Modes
Before and after, drill press vise.
bollie7 Offline
Freshman
**
Posts: 12
Threads: 1
Joined: May 2012
Location: Hunter Valley, NSW Australia
#11
09-15-2014, 07:26 PM
I wouldn't have thought to paint something like that in black as I would have thought it would not look too good. Its come up surprisingly well. Looks lovely.
Dont see a buttress thread much these days.
bollie7
bollie7, proud to be a member of MetalworkingFun Forum since May 2012.
Reply
Thanks given by:
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
The following 1 user Likes stevec's post:
EdK (09-16-2014)
#12
09-16-2014, 03:58 PM
(09-12-2014, 01:32 AM)Shawn Wrote: I wasn't going to paint it at all when I first started but the paint was worse than it looked and it gave me a chance to try out the colour. I may paint a lathe flat black this winter so a test run was in order.

Excellent job Shawn, but I don't see how it's a test run for flat black, it sure looks like gloss to me.
( unless you too have a "shiny camera") Rotfl
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
#13
09-16-2014, 09:26 PM
Your right Steve, it's not flat black it's Satin Black. I doubt I will use it again, I'm starting to have an affinity to plain old machine grey ?

Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#14
09-17-2014, 01:36 PM
Well I think it looks very smart Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
bubby-joe Offline
Freshman
**
Posts: 5
Threads: 0
Joined: Apr 2014
Location: B.C. Canada
#15
10-16-2014, 02:24 PM
Makes me want to go repaint my motorcycle frame looks very sharp
bubby-joe, proud to be a member of MetalworkingFun Forum since Apr 2014.
Reply
Thanks given by:
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#16
10-16-2014, 07:27 PM
(10-16-2014, 02:24 PM)bubby-joe Wrote: Makes me want to go repaint my motorcycle frame looks very sharp

What make & model of motorbike? Is it a build in progress or something you'd have to disassemble?

BTW, welcome! ....from a fellow motorcyclist & machinist.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)