06-20-2014, 03:41 PM
Ed, Willie,
On the apex of the 'V' there looks to be a flat or rounded off. Can you please say if it is rounded or flat and a rough idea of the size - just roughly will be fine. Thanks.
I keep having a look at machining this 'V' ............ think I'm going back to the vice and the rotary table.![Smile Smile](http://www.metalworkingfun.com/images/smilies/smile.gif)
![Smiley-eatdrink004 Smiley-eatdrink004](http://www.metalworkingfun.com/images/smilies/smiley-eatdrink004.gif)
DaveH
On the apex of the 'V' there looks to be a flat or rounded off. Can you please say if it is rounded or flat and a rough idea of the size - just roughly will be fine. Thanks.
I keep having a look at machining this 'V' ............ think I'm going back to the vice and the rotary table.
![Smile Smile](http://www.metalworkingfun.com/images/smilies/smile.gif)
![Smiley-eatdrink004 Smiley-eatdrink004](http://www.metalworkingfun.com/images/smilies/smiley-eatdrink004.gif)
DaveH