MetalworkingFun Forum › Machining › CNC v
Knurling Vial Caps

Thread Modes
Knurling Vial Caps
awemawson Offline
Junior
****
Posts: 642
Threads: 14
Joined: Oct 2013
Location: East Sussex, UK
#21
10-19-2013, 10:16 AM
If your parting tool insert was of the 'R' spec the pip would be left on the scrap and the part would be finished if you are dead nuts on centre, thus saving a second op.
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
12345678910 Offline
Freshman
**
Posts: 45
Threads: 5
Joined: Jul 2013
Location: Ontario, Canada
#22
10-19-2013, 03:21 PM
I missed this part altogether, what are these vials good for ?

Are they liquid tight ?
Reply
Thanks given by:
wrustle Offline
Junior
****
Posts: 438
Threads: 67
Joined: Sep 2012
Location: Central Mass.
#23
10-19-2013, 03:45 PM
(10-19-2013, 03:21 PM)12345678910 Wrote: I missed this part altogether, what are these vials good for ?

Are they liquid tight ?

We just make the parts. What they are used for, I do not know.

This customer of ours makes forensic test equipment.

Best Regards,
Russ
Reply
Thanks given by:
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
The following 1 user Likes stevec's post:
wrustle (10-20-2013)
#24
10-19-2013, 06:25 PM
123... Russ was polite enough not to say that these vials are good for a loss. The next order is good for a tidy profit. Rotfl
Blush
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)