Power Crossfeed for Asian 9X20s

[TomG]

(07-26-2013, 03:50 PM)tekfab Wrote: Bull***t ! Grey is a colour of boredom ! as in the expresion "a grey day" Who wants to stand in front of a grey machine all day ? if that didn't drive you to drink then i don't know what would ?
Paint your machine whatever colour takes your fancy, it is your machine after all and if you come to sell it then the new owner can paint it whatever colour he wants.
Bring on the hippy milling machines !

Mike

Lol, I've worked on brightly painted machines. It seemed like a good idea at first, but after a few shifts I was ready to gouge my eyes out. How about grey, pin striped in yellow, a nice lime green, or maybe even plum crazy purple?

Tom

[Mayhem]

I've seen pictures of a BP that was painted in bright yellow. It actually looked pretty good.

[Bill Gruby]

Yellow BP, ouch. OK started the clutch. I need to add the rear set screw and the 10 index holes in the flange and part #1 is done.

"Billy G"

[Bill Gruby]

Still no pulleys. Dang. OK 19 engagement holes this part is finished.

"Billy G"

[dallen]

nice job Bob, this is interesting as I have a 9 inch lathe similar to yours I may do the same too, I notice that you did the reverse modification to your lathe mine if I ask how you installed it?.

DA

[Bill Gruby]

The tumbler reverse on mine is a clone from the Steve Bedair site.

Made the drive pin tomorrow I will make the slots and spring load it.

"Billy G"

[DaveH]

Very neat

DaveH

[Bill Gruby]

Dave. Pulleys are here but it's too late to do anything with them today. Rework tomorrow.

"Billy G"

[Bill Gruby]

I don't care what she says, it's tomorrow somewhere.

#1 is fitted.

"Billy G"

[TomG]

I knew you couldn't resist.