Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
I'll be following your every move Ed.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Posts: 8,842
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
(10-24-2012, 07:10 PM)stevec Wrote: I'll be following your every move Ed.
Ah, OK, the pressure is on. I'll try not to disappoint you.
Ed
P.S. We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
(10-24-2012, 07:13 PM)EdK Wrote: We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.
Eeeuw!
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Posts: 8,842
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
Finally got back to this project. The large dovetail cutter was too large for the slot so I had to start with the small cutter and mill to its max and then switch over to the large cutter. Small cutter done, now on to the large cutter for the final dimensions.
Ed
Posts: 825
Threads: 25
Joined: Jul 2012
Location: N. Bay Ontario
Very nice work Ed!! (Be sure to mark your'e name and date on things you make!!)
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
Looking good Ed
Daveh
Posts: 8,842
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
The block is done. Just a few small pieces to make and this project is history.
Ed
Posts: 8,842
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
More progress on this project. Getting close to crossing it off of my long list.
Ed
Posts: 4,438
Threads: 183
Joined: Feb 2012
Location: Missouri, USA
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
Ed,
Nice work
DaveH