Lathe cross slide hole driller.
#11
Nice work Bob. Two questions:
1. Where did you buy the degree wheel?
2. What are you drilling on the cross slide handle? I can't tell from the pic.
Hunting American dentists since 2015.
Reply
Thanks given by:
#12
The cross slide handle has a 1/8" keeper drilled to keep the handle from spinning on the threads. I shortened the shaft for a PM member who couldn't do it because his lathe was missing the shaft.
The degree wheel is from http://www.mcmaster.com http://www.mcmaster.com/#protractor-dials/=gulle8 They may not ship overseas but i can ship one if you like. I will post the pics on how i made mine...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)