Making A QCTP Indicator Holder
#41
I'll be following your every move Ed.Thumbsup
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#42
(10-24-2012, 07:10 PM)stevec Wrote: I'll be following your every move Ed.Thumbsup

Ah, OK, the pressure is on. I'll try not to disappoint you. Big Grin

Ed

P.S. We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.
Reply
Thanks given by:
#43
(10-24-2012, 07:13 PM)EdK Wrote: We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.
Eeeuw!
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#44
Finally got back to this project. The large dovetail cutter was too large for the slot so I had to start with the small cutter and mill to its max and then switch over to the large cutter. Small cutter done, now on to the large cutter for the final dimensions.

Ed

   
Reply
Thanks given by:
#45
Very nice work Ed!! (Be sure to mark your'e name and date on things you make!!)
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by: EdK
#46
Looking good Ed Smiley-signs107
Smiley-eatdrink004
Daveh
Reply
Thanks given by: EdK
#47
The block is done. Just a few small pieces to make and this project is history. Smile

Ed

   
Reply
Thanks given by:
#48
More progress on this project. Getting close to crossing it off of my long list. Happyyes

Ed

   

   
Reply
Thanks given by:
#49
Looking good Ed.

I think you have been sandbagging us..... Chin

Big Grin Big Grin Big Grin
Willie
Reply
Thanks given by: EdK
#50
Ed,
Nice work Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by: EdK




Users browsing this thread: 1 Guest(s)