DI chuck adapter

[TOM REED]

Ed this thread is just for you although I plan to make one of these myself to use my 4 jaw from the lathe on my rotary table http://www.homemodelenginemachinist.com/...pic=5495.0 this is a link to an article on HMEM Hone Model Engine Machinist that I thyink you will find interesting on making an adapter for the rotary table which will allow you to use your D! chucks directly on the rotary table. tom

I think this is the proper way to post articles from other sites.

[EdK]

(03-18-2012, 11:00 PM)TOM REED Wrote: I think this is the proper way to post articles from other sites.

Perfectly done Tom.

Ed