Making A QCTP Indicator Holder

[stevec]

I'll be following your every move Ed.

[EdK]

(10-24-2012, 07:10 PM)stevec Wrote: I'll be following your every move Ed.

Ah, OK, the pressure is on. I'll try not to disappoint you.

Ed

P.S. We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.

[stevec]

(10-24-2012, 07:13 PM)EdK Wrote: We're expecting our first snow tomorrow. 1.4" of the white fluffy stuff. Yuk! I'm getting too old for that stuff.

Eeeuw!

[EdK]

Finally got back to this project. The large dovetail cutter was too large for the slot so I had to start with the small cutter and mill to its max and then switch over to the large cutter. Small cutter done, now on to the large cutter for the final dimensions.

Ed

   

[sasquatch]

Very nice work Ed!! (Be sure to mark your'e name and date on things you make!!)

[DaveH]

Looking good Ed

Daveh

[EdK]

The block is done. Just a few small pieces to make and this project is history.

Ed

   

[EdK]

More progress on this project. Getting close to crossing it off of my long list.

Ed

   

   

[Highpower]

Looking good Ed.

I think you have been sandbagging us.....

[DaveH]

Ed,
Nice work

DaveH