09-24-2012, 09:45 AM
Making An Outboard Spider
|
09-24-2012, 10:00 AM
09-24-2012, 12:53 PM
I've seen the posts of you and Tom working on them but haven't a clue as to what they're for. But then clueless isn't uncommon for me. Nice work, what ever they are.
Free advice is worth exactly what you payed for it.
Greg
09-24-2012, 01:06 PM
(09-24-2012, 12:53 PM)f350ca Wrote: I've seen the posts of you and Tom working on them but haven't a clew as to what they're for. But then clueless isn't uncommon for me. Nice work, what ever they are. Greg, Mine will be used on the outboard end of the spindle to hold long stock through the spindle. I think Tom's will be used on the inboard side of the spindle since he turned a taper on his to match his spindle taper, but I'll let him verify that. Clear as mud? Ed
09-24-2012, 03:03 PM
Ed, my Lux-Matter lathe came with a threaded "bushing" for the outboard (left end of the spindle). The spindle was threaded internally for that purpose.
The "bushing had a couple of inserts and I assume the previous owner had sized the inserts for the sizes of the material they worked. Of course an adjustable one like you're making would be more suited to our varying non-production needs.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
09-24-2012, 03:50 PM
Steve,
Most lathes I've seen have either the ID or OD of the spindle threaded but my lathe has neither so it'll be a clamp style. I wish it was threaded because then I wouldn't have to remove the cover to install it. I'm incredibly lazy at times, that would be most times. Ed
09-24-2012, 04:36 PM
(09-24-2012, 01:06 PM)EdK Wrote: Greg, I'm actually making one for both ends of the spindle. The point contact of the set screws is less apt to distort something as long and skinny as a rifle barrel than trying to hold it with a collet or chuck. Nice finish on your cat head Ed, what kind of steel are you using? Tom
09-24-2012, 04:58 PM
(09-24-2012, 04:36 PM)TomG Wrote: Nice finish on your cat head Ed, what kind of steel are you using? Thanks Tom. I'm not sure what type of steel it is. I thought at first it might be 12L14 but it's been sitting in my basement for years and had no rust on it so I'm questioning that since leaded steel will rust if you look at it the wrong way. I've been using carbide insert tooling to bore and turn it and when I do the final cut I set the autofeed for the finest cut. That makes a big difference in the finish. Ed |
« Next Oldest | Next Newest »
|
Users browsing this thread: 2 Guest(s)