MetalworkingFun Forum
today's casting - Printable Version

+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Welding & Casting (http://www.metalworkingfun.com/forum-9.html)
+--- Thread: today's casting (/thread-941.html)

Pages: 1 2 3 4 5


today's casting - dallen - 10-26-2012

or part of the ones I did today. I did two cast of these grips but only one got close enough to say I would keep them. Still have some bugs to work out on the molding stage.

[Image: hand-grips.jpg]


RE: today's casting - dallen - 11-02-2012

here's a couple of photos of the grips that I have been trying to cast the last couple of days.

[Image: hand-grips002.jpg]

[Image: hand-grips001.jpg]

figured out a couple of things and these came out a whole lot better. Still need to do the holes and counterbores, but not bad for an ole country boy!


RE: today's casting - doubleboost - 11-02-2012

They look like nice solid castingsWorthyWorthyWorthy
John


RE: today's casting - EdK - 11-02-2012

Definitely nice David! Keep the pictures coming. Happyyes

Ed


RE: today's casting - DaveH - 11-02-2012

DA,
Very nice Smiley-signs107
Smiley-eatdrink004
DaveH


RE: today's casting - dallen - 11-02-2012

will have to take a snap of the flask I had to make to do them in don't know why I haven't already taken on of it, also need to make one a little bit larger so I can do both at one time.


RE: today's casting - stevec - 11-03-2012

A "snap of the flask" had me going but I think I understand now.BlushRotfl


RE: today's casting - dallen - 11-03-2012

(11-03-2012, 07:32 AM)stevec Wrote: A "snap of the flask" had me going but I think I understand now.BlushRotfl

snap = snapshot, photograph, picture, sorry for the confusion Steve they do make whats called a snap flask. which I don't happen to have any of.Smile


RE: today's casting - dallen - 11-03-2012

here's what they look like installed

[Image: hand-grips003.jpg]


RE: today's casting - EdK - 11-03-2012

Looks like a good fit. Is that aluminum you cast it out of?

Ed